
Directions for use
Trap Operation Instructions
- Switch OFF (Fig A) and remove batteries. Open the trap by holding the base of the trap with your left hand and sliding the top backwards with your right hand (Fig B). Pull top away from base. Ensure unit is clean and free from any foreign items (Fig C). Re-apply top by holding base of the trap with your left hand and slide top into place by pushing forward with your right hand to reconnect (Fig D).
- Baiting: Open bait door. Use pea-sized amount of peanut butter or Ratsak® rat attractant in bait door only. Apply bait using gloves, a toothpick or other tool to mask your scent (Fig E). Warning: Any bait touching the metal may cause malfunction.
- Power: Insert x4 C batteries.
- Trap placement: Place the trap on a clean, dry surface along a wall. Turn the switch to the ON position. The green light will blink/flash once and the unit will buzz for a few seconds when enabled (Fig F). The green light will then go off.
- LED light: Flashing green: rodent caught (flashes for 1 week) Red: replace batteries.
- Rodent disposal: Turn the switch to OFF and remove batteries. Open the trap by holding base of the trap with your left hand and sliding the top backwards with your right hand. Pull top away from base and properly discard dead rodent.
Trap Cleaning Instructions
(Only clean when necessary – when debris remains on shock plates)
- Disassembly: Switch OFF (Fig A) and remove batteries. Open the trap by holding the base of the trap with your left hand and sliding the top backwards with your right hand (Fig B). Pull top away from base (Fig C).
- Cleaning: The kill chamber (base) is now ready for cleaning. Use soft bristle brush and warm water to scrub inside of chamber (hydrogen peroxide topical solution may also be used). DO NOT get water on electronics housing.
- Drying: Thoroughly dry interior and exterior of kill chamber, or allow to air dry, prior to trap reassembly. Ensure unit is completely dry before reuse. Dry hands thoroughly.
- Assembly: Re-apply top by holding base of the trap with your left hand and slide top into place by pushing forward with your right hand to reconnect (Fig D).
- Reuse: Trap is ready to use. Follow trap operation instructions steps 1-6.
Handy rodent control tips
- Eliminate as far as practical all alternative food sources.
- Keep food stored in sealed containers.
- Consider using gloves when setting the trap to avoid the rodent detecting human scent.
- Move the traps to a new location after 48 hours if rats are still present.
- Bait with Peanut Butter to attract the rodent, or use cheese if no peanut butter is available. For extra results, use Ratsak Attract paste.
- Repair holes, cracks and cervices that may encourage rats to enter the building. Or use Ratsak Repel solutions to prevent new rodents.
* If used as directed. With fully charged batteries and rodent fully committed to trap.
^ Batteries not included.
NOT TO BE USED FOR ANY PURPOSE OR IN ANY MANNER CONTRARY TO THIS LABEL UNLESS AUTHORISED
Share
Share this article on social media